انجمن تخصصی فلزیاب و ردیاب
تاریخ : سه شنبه 25 شهریور93 - 5:54pm



پاسخ به موضوع  [ 3 پست ] 
 اپراتوری دلتا پالس3 
نویسنده پیغام
کاربر فعال
کاربر فعال

تاریخ عضویت: دوشنبه 2 اردیبهشت92 - 9:05pm
پست: 83
dp3شامل 6تا منوست. power ferequency-power
Gain auto seeting
sample auto seeting
trs. threshold sonud
auto ground gap low normal high sound
sets language light led disc. data save auto setting


دوشنبه 24 تیر92 - 3:43pm
کاربر فعال
کاربر فعال

تاریخ عضویت: دوشنبه 2 اردیبهشت92 - 9:05pm
پست: 83
Frequency:
This term is used for number of pulses to send in a second.
By increasing frequency you will get quicker auto adjustment to different lands. But be aware when using the device with high frequency you will run out your battery more quickly. Just decide for a more responsive device against running out the battery more quickly.

Power:
This term is used for duration of each pulse.
If you increase the power you will get more deeper detection accordinly. But again you will run out the battery more quickly like frequency adjustment. More importantly, using high power mode, device will be much responsive against mineralization. So, use it in lowest possible values and increase as required.

Gain:
This term is used for gain factor in analog circuit of device. If you increase gain device will detect more deeper and be more responsive to mineralization. Start with lowest value available and increase it up to the point that you don't get false detection. Don't try to increase gain in a room full of metals, you can't make the device silent. Adjust the gain outdoor that you sure that no mineralization around. If you need to make test in a room, just use value "1".

Sample:
This term is used for discrimination of metals from dampening slope. It will define the start and finish points of sampling. These values are very important either in analog and digital circuit of device. A good adjusted sampling point will give the device best perpormance for deepest detection and disc. But these values that are auto adjusted according the objects under the coil when bootup or pressing to tune button. Device can make false detections when you move to less mineralized media to more mineralized media. This is why these parameters need to be adjusted manualy or you can simply press "tune" button for auto adjustment.

sample start:
This parameter is adjusting the start of sampling point from dampening slope. By this adjustment discrimination level and responsivness by metal type can be achived. when increased, responsivness to mineralization will go lower, but, at the same time yo will get less distance for detection and less disc. level for valuable metals. when decreased, responsivness to mineralization will be higher, but, at the same time yo will get more distance for detection and more disc. level for valuable metals.
It migth be choosen using with 1 or 2 step over auto adjusted value when used in mineralized lands.

sample finish:
with this parameter you can adjust the finish point of sample from dampening slope. With this adjustment you can define the responsivness of device to electromagnetic noise and ferro metals. By lowering this parameter you will get lower responsiveness to ferro. But, at the same time lowering this parameter adversely affecting detection depth of device.

Treshold:
This will define the value that detector give signal when it is reached. This parameter need a fine adjustment very closely to the level that device be silent, so this will help deepest detection. While this adjusted very near to silent/loudy border, device will be more responsive to little objects and mineralization.
این متن بود که از 2سایتش گرفتم.اگه کسی چیزه دیگه ای میدونه به اشتراک بزاره.


چهارشنبه 2 مرداد92 - 3:13pm

تاریخ عضویت: چهارشنبه 18 تیر92 - 12:16am
پست: 15
حداقل با ترانسلیت ترجمش میکردی بعد میزاشتی بازم ممنون لطف کردی/


چهارشنبه 22 بهمن92 - 4:05am
نمایش پست ها از آخر به اول:  مرتب سازی بر اساس  
پاسخ به موضوع   [ 3 پست ] 

چه کسی آنلاین است؟

کاربران حاضر در این انجمن : کاربر عضو شده ای موجود نیست. و 3 مهمان


در این انجمن نمی توانید موضوعات جدیدی ارسال کنید
در این انجمن نمی توانید به موضوعات پاسخ دهید
در این انجمن نمی توانید پست خود را ویرایش کنید
در این انجمن نمی توانید پست های خود را حذف کنید
در این انجمن نمی توانید پیوست ارسال کنید

انجمن و سایت تخصصی فلزیاب و ردیاب با حضور اساتید مجرب - طراحی و ساخت و خرید و فروش مدارات الکترونیک و کیت و نقشه مدار دستگاههای پر قدرت فلز یاب و رد یاب با قیمت مناسب - دستگاه گنج یاب و دفینه یاب و گنجیاب جهت جستجوی طلا - بهترین و قویترین طلایاب و سیستم تصویری و فلزیاب پالسی و توباکس - آموزش اپراتوری ردیاب - best site / forum for metal detector (PI, VLF, Two Box, ...) , lrl , felezyab , felez yab systems to find treasure